Debugging 64 bit Tridion content delivery on IIS 7.5
I'm currently developing a web application which will run on Windows 2008 R2 and which is intended to run in a 64bit Application pool. This means that I'm running IIS 7.5, and that the web application is installed with the 64 bit versions of the Tridion content delivery assemblies. As you'll know if you've tried to run this kind of web application in a 32 bit process, you pretty soon get exceptions telling you that you have an invalid format. This gets a little inconvenient if you just start to debug your web application in Visual Studio. By default, if you have a page selected, and hit the big green Run triangle, the page will launch in IIS Express. If you have IIS 7.5, then IIS Express runs a 32 bit process, so the default setup just isn't going to work for you.
So - what to do? I had two options:
- Configure the properties of the web application to debug using IIS rather than IIS Express
- Launch the web page directly from the browser, and attach the debugger to the correct w3wp.exe process.
To be honest, the second of these was the choice that most matched my usual debugging approaches. Having said that, I did try the first approach, but so far without success. Visual Studio 2012 has frozen on me a few times while trying this. I'm interested if anyone has any tips on getting this working, but right now, I'm happy enough that I was able to succeed in attaching a debugger to w3wp.exe.
My biggest challenge was to figure out which process I wanted to attach to. On my development server, I have quite a few web sites running, and it's not altogether obvious which w3wp.exe to attach to. Attaching to them all might work in a trivial case, but realistically, it takes quite a while to load all the dlls, and adding any more processes than necessary is just going to hurt too much. So - how do you find out which process it is?
The first step is to ensure you have the IIS powershell provider installed on your server. These days, this is shipped as a module, so if it's available on your system, you should be able to open a powershell and type:
If the response includes "WebAdministration" you are good to go. Just import the module as follows:
If this succeeds, you should be able to "change directory" into the IIS provider. (Although a PowerShell purist might prefer set-location... whatever floats your boat!)
If you can't find the module, then go into the Server manager, and check that you have the relevant role services for IIS installed. On other platforms, you might find that you can install it from the WebInstaller from the MSDN web site.
Now you're ready to find the process that you want to attach to: Assuming that your application pool is called "MyApplicationPool", then you can list its worker processes like this: (or use "dir" or "ls", either of which is an alias for "gci")
> gci IIS:\AppPools\MyApplicationPool\WorkerProcesses
Process State Handles Start Time Id -------- ----- ------- ---------- 2608 Running 776 1/2/2013 6:55:33 PM
This assumes, of course, that your app pool is actually running, but you'd have made sure it was before trying to debug it, right. Anyway - as you can see, the process id is there just to read off, and you can get straight on with your debugging session.